Extron electronic USP 507 manual Advanced configuration, To remove an image from the display

Front Panel Operation, cont’d

Step 1

MENU

Press NEXT twice

LCD screen displays

Recall to back:

<N/A>

MENU

Press

three NEXT times

ADJUST

LCD screen displays

Recall to front:

<N/A>

LCD screen displays

Rotate either	Recall:
Adjust knob.	IMG05.BMP

Step 2

	MENU
Press	NEXT

LCD screen displays

Recalling Image

Please wait

then

IMG05.BMP

Recalled

To remove an image from the display:

1. Press Next twice. The LCD displays “Recall to back: <N/A>”. If the image is displayed at the front, press Next again so the LCD displays “Recall to Front: <N/A>”.

2.With the appropriate “Recall to back: <N/A>” or “Recall to front: <N/A>” displayed, press Next. The current image is removed from the display, but not from the USP 507 memory. To recall the image follow the steps described in the “To recall an image” section, on this page.

Advanced configuration

Within this menu auto imaging and auto memory can be turned on or off, Input EDID can be set, RGB delay value adjusted, the switch effect chosen, a test pattern selected to aid setting up the display, and the MTP pre-peaking turned on or off. In addition the internal temperature can be read, and the unit can reset to factory default settings.

NAt any submenu, if the input is incorrect, press the desired input button, and then proceed with the setting adjustment.

1. Press Next to enter the first sublevel, Auto Image. The current active input and setting status is displayed. See the table below for a full description of the interaction between the auto image and auto memory settings.

Auto Image Input #2 On

		Auto Memory and Auto-Image Features
Auto Memory	Auto Image	Information
ON	ON	“New” signals /rates that have not been previously detected by the USP 507 are initially set-up
		using default parameters, then auto image is automatically applied and values stored. The next
		time the same signal is detected, the values stored in the auto memory location are applied.
ON	OFF	“New” signals /rates that have not been previously detected by the USP 507 are set-up using
(Default)	(Default)	default parameters. If manual input and/or picture settings are made to the input, an auto
		memory location is created and recalled each successive time the input is detected.
OFF	ON	Each change in input sync triggers an automatic auto image. When auto memory is disabled,
		each different signal is treated as a new signal and default picture controls and automatic auto
		image is applied. Any manual changes made to the image and picture controls are lost each time
		a new rate is detected.
OFF	OFF	Each change in input sync causes default values to be applied to the rate. Any manual changes
		made to the image and picture controls are lost each time a new rate is applied.

Figure 3-6 — Auto Memory and Auto-Image features table

3-10 USP 507 • Front Panel Operation