Extron electronic Click Connect to Matrix button. The, USP 507 Input #3 select the matrix

Input 1

Input 2

Input 3

Input 4

Input 5

Input 6

Input 63

Input 64

Matrix Switcher

Output 1	Input 3
Output 2	Input 3
Output 3
Output 4
Output 5
Output 6	Input 3

Output 63

Output 64

USP 507	#1
USP 507	#2
(optional)

USP 507 #6

(optional)

Output to display

Output to display

Output to display

Figure 3-9 — Multiple USP 507’s connected to a matrix switcher

3. On the USP 507, configure the input as follows: a. Switch to input 3 on the USP 507.

b. Set the following input sampling settings as needed: signal type, horizontal and vertical start, pixel phase, total pixels, active pixels, and active lines.

NDo not use the auto detect setting for the input type when using input presets.

c. Set the following picture controls as needed: size, position, color, tint, brightness, contrast, and detail.

d. Save the adjusted settings as input preset 1. Refer to chapter 4, “SIS

Programmers Guide”, for the SIS commands to save the preset.

NEach input preset must be saved with the same number as the input on the matrix switcher. For example, input 24 on the matrix will be associated with the input preset 24 on the USP 507.

e.	Repeat steps 2 and 3 for each matrix input that is used on the USP 507.
4. Synchronize the USP 507 to the matrix switcher as follows:
a.	Open the control program (SPPCP) and connect to the USP 507.
N Connection must be via IP (not RS-232).
b.	From the Tools menu, select Sync to
	Matrix Switcher... . The Sync to Matrix
	Switcher window opens
c.	In the IP Address field, enter the matrix
	switcher’s IP address.
d.	Click Connect to Matrix button. The
	matrix switcher’s size is displayed.
e.	From the drop-down menu next to
	USP 507 Input #3 select the matrix

output number that is connected to

input 3 on the USP 507. Click Take. The devices now synchronize.

NAll other inputs on the USP 507 must not be used when it is synchronized to a matrix switcher.

USP 507 • Front Panel Operation 3-15