Extron electronic manual FrontPanelOperation,co t’d, The USP 507 Menu System, Overview of menus

FrontPanelOperation,co t’d

The USP 507 Menu System

The USP 507 can be configured using the menu system, via the Extron Simple Instruction Set (SIS™) of commands through an RS-232 or LAN connected PC, or via the Extron software program, SPPCP.

NFor SIS commands and SPPCP configuration methods see chapters 4 and 5.

There are seven front panel configuration menus: User Presets, Input Configuration, Output Configuration, Image Capture/Recall, Advanced Configuration, and View Comm Settings. A hidden menu (Edit Comm Settings) is also accessible. If an optional Scan Converter board is installed, an eighth menu (scan converter menu) is available.

User	Menu	Input	Menu	Output	Menu	Image
Presets		Configuration		Configuration		Capture/Recall
						Menu
	Menu				Menu
Advanced		View Comm	Menu	Scan		Exit Menu
Configuration		Settings		Converter		Press NEXT
				only where optional Scan
				Converter card is installed

Overview of menus

User Presets

This menu allows the user to save the current image settings to a preset number (1-16 for each input), and recall any saved preset as the current image settings.

Input Configuration

This menu allows configuration of the following settings for any selected input: Input type, film detection, vertical and horizontal start points, pixel phase, the number of total and active pixels and the number of active lines.

Output Configuration

This menu allows configuration of the following settings for the active output: resolution and refresh rate (see page 3-8), output type, and sync polarity.

Image Capture/Recall

This menu allows any one of up to 16 stored images to be recalled to the display, as either a background to an active video signal, or in front of the active signal. It also allows the user to store the current displayed image on the device for later recall.

Advanced Configuration

This menu allows advanced configuration of the following USP 507 settings: auto image, input EDID, auto memories, RGB delay, switch effect, test pattern, MTP pre-peaking, internal temp (view only), and resetting to factory defaults.

View Comm Settings

This menu allows the user to view the following serial and IP settings for the unit: serial port baud rate, MAC address, DHCP (Dynamic Host Configuration Protocol) setting, IP address, subnet mask address, and gateway address.

NThese settings can not be edited from within this menu. See next section.

Edit Comm Settings (hidden)

To display and enter this menu, press and hold the Detail and Color/Tint buttons simultaneously and then press Next. The hidden menu appears.

This menu allows the user to edit the following serial and IP settings:

serial port baud rate, DHCP mode, IP address, subnet mask, and gateway address.

Scan Converter Configuration

This menu, displayed only when the optional scan-converter board is installed, allows the user to configure the settings for scan-converted outputs.

Exit Menu

At this menu pressing Next exits the menu system and returns to the default cycle.

3-4 USP 507 • Front Panel Operation