Extron electronic USP 507 DHCP radio buttons, Gateway IP Address field, Subnet Mask field

DHCP radio buttons

The DHCP On radio button directs the device to ignore any entered IP addresses and to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the network is DHCP capable).

The DHCP Off radio button turns DHCP off. Contact the local system administrator to determine this control’s setting.

IP Address field

The IP address field contains the IP address of the USP 507. This value is encoded in the unit’s flash memory.

Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots (periods). Each field can be numbered from 000 through 255. Leading zeros, up to 3 digits total per field, are optional. Values of 256 and above are invalid.

The factory-installed default address is 192.168.254.254, but if this conflicts with other equipment at your installation, you can change the IP address to any valid value.

NIP address changes can cause conflicts with other equipment. Only local system administrators should change IP addresses.

Gateway IP Address field

The gateway IP address field identifies the address of the gateway to the mail server to be used if the device and the mail server are not on the same subnet.

The gateway IP address has the same validity rules as the system IP address.

Subnet Mask field

The Subnet Mask field is used to determine whether the USP 507 is on the same subnet as the mail server when you are subnetting. For more information, see “Subnetting — A Primer”, in Appendix B, “Ethernet Connection”.

MAC Address field

The Media Access Control (MAC) address is hard coded in the device and cannot pobe changed.

Firmware field

This field shows the firmware version number. This field changes only when the firmware is updated.

Model field

This field shows the model (USP 507) and cannot be changed.

Part Number field

This field shows the USP 507 part number (60-1055-xx) and cannot be changed.

USP 507 • HTML Operation 6-5