Extron electronic Installation, cont’d, USP 507 Reset Mode Summary, 2-8USP 507 Installation

Installation, cont’d

USP 507 Reset Mode Summary

		Mode Activation	Result	Purpose/Notes
		1 Hold down the recessed Reset button	The USP 507 reverts to the factory default firmware.	This mode reverts to
		while applying power to the unit.	Event scripting does not start if the device is powered	the factory default
FactoryUse Firmware		N After a mode 1 reset is performed,	on in this mode. All user files and settings (drivers,	firmware version if
			adjustments, IP settings, etc.) are maintained.	incompatibility issues
		update the USP 507 firmware to the
				using an earlier
		latest version. The reset tofactory intsled	N If you do not want to update firmware, or you	arise with user-loaded
		firmware is temporary. When power is	performed a mode 1 reset by mistake, cycle power to the	firmware.
		cycled, the unit uses the last installed	device to return to the firmware version that was	N User-defined
		firmware. Do not operate the firmware	running prior to the mode 1 reset. Use the 0Q SIS	Web pages may not
		version that results from this mode reset.	command to confirm that the factory default firmware is	work correctly if
		If you want to use the factory default	no longer running (look for asterisks following the version	firmware version.
		firmware, you must upload that version	number.)
		again. See page 6-10 for details on
		uploading firmware.
Run/Stop	Events	3 Hold down the Reset button for about 3	This Mode turns events on or off.	This mode is useful
		sec. until the Power LED blinks once,	N Nothing happens if the momentary press	for troubleshooting.
		then release and press Reset
			does not occur within 1 second. During resetting LED
		momentarily (<1 sec.) within 1 second.
			flashes twice if events are starting, and three times if
			events are stopping.
		4 Hold down the Reset button for about	This Mode:	This mode enables
allReset SettingsIP		6 sec. until the Power LED blinks twice	• Enables ARP capability.	you to set IP address
		(once at 3 sec., again at 6 sec.). Then	• Sets the IP address back to factory default	information using
		release and press Reset momentarily	(192.168.254.254).	ARP and the MAC
		(for <1 sec.) within 1 second.	• Sets the subnet back to factory default.	address.
		N Nothing happens if the momentary	• Sets the default gateway address to the factory default.
			• Sets port mapping back to factory default.
		press does not occur within 1 second.
			• Turns DHCP off.
			• Turns events off.
toReset DefaultsFactory		5 Hold down the Reset button for about	This Mode performs a complete reset to factory	This mode is useful if
		9 sec. until the Power LED blinks three	defaults (except the firmware).	you want to start over
		times (once at 3 sec., again at 6 sec.,	• Does everything mode 4 does.	with configuration
		again at 9 sec.). Then release and press	• Resets all IP options.	and uploading, and
		Reset momentarily (for <1 sec.) within	• Removes scheduling settings.	also to replace events.
		1 second.	• Removes/clears all files from the USP 507.
		N Nothing happens if the momentary	• Resets all user video settings.
		press does not occur within 1 second.

2-8 USP 507 • Installation