Extron electronic Sync, Control/remote— signal processor, USP 507 • Reference Information

Nominal level	1 Vp-p for Y of component video and S-video, and for G of RGsB
	0.8 Vp-p for SDI
	0.7 Vp-p for RGB and for R-Y and B-Y of component video
	0.3 Vp-p for C of S-video
Minimum/maximum levels	0.0 V to 1.0 Vp-p
Impedance	75 ohms
Scaled resolution	640x4806,8,9, 800x6006,8,9, 852x4806,8,9, 1024x7686,8,9, 1024x8526,8,9, 1024x10246,8,9,
	1280x7686,8,9, 1280x8006,8,9, 1280x10246,8,9, 1360x7656,8,9, 1360x7686,8,9,
	1365x7686,8,9, 1365x10246,8,9, 1366x7686,8,9, 1400x10506,8, 1440x9006,8,9,
	1600x12006,8, 1680x10506,8, 1920x12006,8
	HDTV: 480p7,8, 576p6, 720p3,4,5,6,7,8, 1080i6,7,8, 1080p1,2,3,4,5,6,7,8, 2048x10801,2,3,4,5,6,7,8
	1 = 23.98 Hz, 2 = 24 Hz, 3 = 25 Hz, 4 = 29.97 Hz, 5 = 30 Hz, 6 = 50 Hz,
	7 = 59.94 Hz, 8 = 60 Hz, 9 = 75 Hz

Sync

Input type	RGBHV, RGBS, RGsB, RGBcvS, and component video (tri-level or bi-level)
Output type	RGBHV, RGBS, RGsB, and component video (tri-level or bi-level)
Standards	NTSC 3.58, PAL
	Optional SDI/HD-SDI input: SMPTE 259M-C, SMPTE 292M
Input level	2.75 V to 5.0 Vp-p for RGBHV or RGBS
	0.6	Vp-p for component video tri-level sync
	0.3	Vp-p for component video bi-level sync or RGsB
Output level	5.0 Vp-p for RGBHV or RGBS
	0.6	Vp-p for component video tri-level sync
	0.3	Vp-p for component video bi-level sync or RGsB
Input impedance	Horizontal: 75 ohms
	Vertical: 510 ohms
Output impedance	75 ohms
Polarity	Positive or negative (selectable)

Control/remote— signal processor

Serial control port	2 RS-232/RS-422 on female 9-pin D connectors (rear panel)
	1 RS-232, 2.5 mm mini stereo jack (front panel)
Baud rate and protocol	9600 (default), 19200, 38400, 115200 baud, adjustable; 8 data bits, 1 stop bit,
	no parity
Serial control pin configurations
9-pin D connector	RS-232: 2 = TX, 3 = RX, 5 = GND
	RS-422: 2 = TX-, 3 = RX-, 5 = GND, 7 = RX+, 8 = TX+
2.5 mm mini stereo jack....	Tip = TX, ring = RX, sleeve = GND
Ethernet control port	1 female RJ-45 connector
Ethernet data rate	10/100Base-T, half/full duplex with autodetect
Ethernet protocol	ARP, ICMP (ping), IP, TCP, UDP, DHCP, HTTP, SMTP, Telnet
Ethernet default settings	Link speed and duplex level = autodetected
	IP address = 192.168.254.254
	Subnet mask = 255.255.0.0
	Gateway = 0.0.0.0
	DHCP = off
Web server	Up to 200 simultaneous sessions
	40 MB nonvolatile user memory
Program control	Extron control/configuration program for Windows®
	Extron Simple Instruction Set (SIS™)
	Microsoft® Internet Explorer®, Telnet

USP 507 • Reference Information A-3