Extron electronic USP 507 manual Output configuration

Front Panel Operation, cont’d

Output configuration

Within this menu an outputs resolution, refresh rate, output signal type, and sync polarity can be selected and adjusted. Refer to the table below for applicable resolution and refresh rates.

1.	Press Next to bring up the Resolution submenu. In this submenu, the
	resolution and refresh rate can be adjusted.
2.	Rotate the left front panel knob ([) to adjust the resolution value, and rotate
	the right knob ({) to adjust the refresh rate.
Resolution		23.98 Hz	24 Hz	25 Hz	29.97 Hz	30 Hz	50 Hz	59.94 Hz	*60 Hz	75 Hz
640x480							X		X	X
800x600							X		X	X
852x480							X		X	X
1024x768							X		X	X
1024x852							X		X	X
1024x1024							X		X	X
1280x768							X		X	X
1280x800							X		X	X
1280x1024							X		X	X
1360x765							X		X	X
1360x768							X		X	X
1365x768							X		X	X
1366x768							X		X	X
1365x1024							X		X	X
1440x900							X		X	X
1400x1050							X		X
1680x1050							X		X
1600x1200							X		X
1920x1200							X		X
480p								X	X
576p							X
720p				X	X	X	X	X	X
1080i							X	X	X
1080p		X	X	X	X	X	X	X	X
2048x1080		X	X	X	X	X	X	X	X
(* = default)
Figure 3-5 — Output resolution/refresh rate table
3.	Press Next to enter the next submenu, Output Type. Within this submenu the
	output signal type (RGBHV, RGsB, YUV Bi-Level, or YUV Tri-Level) can be
	selected.
4.	Rotate either front panel Adjust knob ([ {) to select the output signal type.
5.	Press Next to enter the next submenu, Sync Polarity. Within this submenu,
	the Sync Polarity can be set (H- V-, H-V+, H+ V-, or H+ V+).
6.	Rotate either front panel Adjust knob ([ {) to select the sync polarity.

NAn incorrect sync polarity setting will result in the loss of the output image.

7. Press Next or Menu to return to the Output Configuration.

3-8 USP 507 • Front Panel Operation