Extron electronic USP 507 Using the Program, Orientation, 1— The control program main window

3.If you selected TCP/IP tab in step 2, the TCP/IP Connection window appears.

a. Examine the IP Address field, which displays the last IP address entered, or the drop-down box which lists the most recently used IP addresses.

If listed, select the applicable IP address, or enter the correct IP address in the field.

N192.168.254.254 is the factory-specified default IP address.

b. If the unit is password protected, enter the appropriate administrator or user password in the Password field.

c. Click Connect. The Control Program is ready for operation.

Using the Program

The Signal Processing Products Control Program (SPPCP) is used to configure and operate the USP 507 from the PC on which the program resides.

Orientation

The SPPCP main window (figure 5-1)has four tabs: Control, I/O Configuration, Advanced Settings, Image Capture. A fifth tab appears if an optional scan converter board is installed. Click on each tab as desired.

The menu bar on the main window shows File, Options, Tools, and Help. Click on each as desired.

At the bottom of the window is the status bar, indicating the status of the connection or any configuration error messages.

NFor detailed Signal Processing Product Control Program instructions when the program is open; press F1 or click on Help, Contents.

Figure 5-1 — The control program main window

USP 507 • USP 507 Software 5-3