Finisar manual Configuring Surveyor

Protocol Summary

Display Detail

	Configuring Surveyor	4
	Configuring the Interface
Table 4-1. Configurable Capture View Columns
Capture View Column	Description
Abs Time	The absolute time of arrival for each packet taken from the system
	clock when the capture was performed.
	format: hh:mm:ss.mmm.uuu.nnn where ss=seconds,
	mmm=milliseconds, uuu=microseconds, nnn=nanoseconds
Delta Time	The time between each packet (interpacket gap).
	format: s.mmm.uuu.nnn where s=seconds, mmm=milliseconds,
	uuu=microseconds, nnn=nanoseconds
Elapsed Time	The time stamp of each packet measured from a relative starting
	point. The starting point may be either the module arm time or the
	arrival time of a specific packet. See below for information on setting
	the elapsed time starting point.
Size	The frame size of the packet in bytes.
Status	The Status field indicates if the frame has errors. For good frames, the
	Status field is blank.
Display Network Address	The destination and source IP address.
Cumulative Byte/	The Cumulative Byte Count is a sum of all bytes received to this point
Throughput	in time in a capture file. The Throughput is calculated by dividing the
	cumulative bytes by the elapsed time. The elapsed time is the differ-
	ence is always measured between the module arm time and the time
	stamp of the current packet in the capture file.

Use the middle portion of the dialog box to set up the display of the Summary column. The Summary column will always display. However, this field can just give a very limited synopsis of protocol activity or provide complete details about the protocols used in the packet. Check the Display Detail Protocol Summary box to view detail about all the protocols used in the packet. Leaving the

box unselected gives a synopsis of all protocols in the packet. If you want to display protocol summary details, set the protocols you want to display from the pull-down menu. For example, if you want to display only the Transport layer and below, select Transport Layer. If you are not displaying protocol summary details, the protocol layer you select in the pull-down menu will not affect the display of the Summary.

Select the Display Expert Symptoms check box if you wish to include expert symptom information in the Summary field. Packets that trigger an expert symptom and have expert symptom information will display in reverse video in Capture View.

4-3