Finisar Surveyor manual Pager Settings, Snmp Trap Settings

Alarms 9

Alarm Actions

E-mail settings for Surveyor hosts and THGs hosts are slightly different. For analyzer devices in Surveyor hosts, you set the list e-mail recipients for alarms from the Host → Alarm Setting → E-mail Settings... menu. All other e-mail configuration is performed from the local e-mail utility. For THGs, e-mail is completely configured from the Host → Alarm Setting → E-mail Settings... menu. You set the sender address, SMTP domain, and the SMTP mail server address as well as the list of e-mail recipients for alarms. An example dialog box for setting up e-mail for THGs hosts is shown below.

Figure 9-4. E-Mail Settings for THGs

Pager Settings

The host must have a modem to use a pager. You must set an appropriate delay time when making a call to a pager.

When making a call to a pager, a single number can be configured from the Host → Alarm Setting → Pager Settings... menu. Setting the pager number for alarm actions is a global setting for the host. All alarms reported for analyzer devices in the host will go to the same pager number. public

SNMP Trap Settings

SNMP traps containing alarms can be sent to specified management stations as one of the alarm actions. Each host has its own list of management stations to receive traps. A set of management stations identified by their IP addresses is called a community.

Any alarm, when triggered, is sent to all IP addresses specified in all communities configured for the host.

9-11