Fostex LR16 POST/PRE switch, AUX 1 control, AUX 2 PRE control, AUX 3 Post control, PAN control

Model LR16 [Names and functions]

2

6

9

10

11

12

16

(7) [POST/PRE] switch

	Selects post-fader or pre-fader feed of the AUX 1 buss (each press of
	the switch alternates the selection).
	When the switch is set to the up (				) position, post-fader is
	selected. When the switch is set to the down (					) position,
	pre-fader is selected.
1	(8) [AUX 1] control
	Adjusts the signal level fed to the AUX 1 buss from each input
3	channel. The post-fader or pre-fader signal selected by the [POST/
	PRE] switch is fed to the AUX 1 buss.
4	(9) [AUX 2 (PRE)] control
5	Adjusts the signal level fed to the AUX 2 buss from each input
	channel. The pre-fader signal is fed to the AUX 2 buss.
	(10) [AUX 3 (POST)] control
	Adjusts the signal level fed to the AUX 3 buss from each input
	channel. The post-fader signal is fed to the AUX 3 buss.
	(11) [EFF] send control
	Adjusts the signal level fed to the EFF buss from each input channel.
	The post-fader signal is fed to the EFF buss, therefore, fader setting
	affects the signal sent to the [EFF] buss.
7	(12) [PAN] control
8	Determines the signal balance between the left and right of the
	stereo busses or odd and even busses of group buss pairs 1-2 and
	3-4.
	Rotating the control to the right (clockwise) increases the amount of
	the signal from the channel going to the right of the stereo buss,
	while decreases the amount of the signal going to the left of the
	stereo buss.
	Rotating the control to the left (counterclockwise) increases the
	amount of the signal from the channel going to the left of the stereo
	buss, while decreases the amount of the signal going to the right of
	the stereo buss.
13	(13) [MUTE] switch
	Switches the mute function on or off. When the switch is set to the
	down position (	), the post fader signal of the channel is muted.
	(14) [ST/1-2/3-4] assign switches
14	Assign or deassign the input channel signal to the corresponding
	buss pairs (Stereo, groups 1-2 or groups 3-4). When the switch is set
	to the down position (			), the signal is assigned to the
	corresponding buss pair. You can assign the signal to more than one
	buss pair at the same time.
15	(15) [SOLO] switch
	Switches the solo function on or off. When the switch is set to the
	down position (		), the pre-fader signal can be monitored via the
	solo buss. When the [SOLO] switch on any input channel is set to
	ON, the [SOLO] indicator on the monitor section flashes.

(16) Channel fader

Adjusts the output level of the input channel.

23