Fostex manual Model LR16 Recorder functions / Recording/playback

Model LR16 [Recorder functions / Recording/playback]

(5)Set the [ST] switches on mixer channels 1 through 8 to "ON" ().

<Note>: Make sure that all the [SOLO] switches on the mixer channel to "OFF" and the [MONITOR SELECT] switch is set to "ST".

(6)Raise the [STEREO] fader to the "0" position.

(7)Locate the recorder to the point earlier than the punch-in point and press the [PLAY] key to start playback.

<Hint>: To perform punch in smoothly, it is recommended to play your instru- ment along with the playback sound.

<Memo>: Use channel faders 1 through 8 to adjust the playback signal levels on tracks 1 through 8 individually, and use the [MONITOR] and [PHONES] controls to adjust the total monitor level.

<Note>: You cannot perform punch in/ out successively without stopping the recorder. To perform more than one punch in/out operation, stop the re- corder each time you finish punch in/ out.

(10)Press the [STOP] key to stop the recorder, and locate the recorder back to the punch in position.

<Memo>: By pressing the [STOP] key on the mixer section, the recorder automati- cally skips to the beginning of the project (ABS 0) and stops.

(11)Press the [PLAY] key to play back the project to check the result.

If you are not satisfied with the result, roll back the previous project data before punch in/out (see page 67 for details).

56