Fostex LR16 manual Channel grouping, Solo monitor

Model LR16 [Mixer functions]

• Solo monitor

By setting the [SOLO] switch(es) to ON (), you can solo monitor the corresponding chan- nel signal(s).

If at least one of the [SOLO] switches is set to ON, the [SOLO] indicator slowly flashes.

[SOLO] indicator

Channel grouping

You can group channels to group busses for effective mixing.

Using the channel grouping function, you can adjust levels of grouped channels using a single fader while maintaining the balance between channels.

By setting the group assign switch (1-2 or 3-

4)of a channel to ON, the channel signal is sent to group busses 1 and 2 or 3 and 4. A group buss signal is output from the [GROUP OUT] jacks.

When the [ASSIGN TO STEREO OUT] switch above the group fader is set to ON, the group buss signal is output to the corresponding stereo buss.

You can find the [SOLO] switches on chan- nels 1 through 16, the effect send, and AUX sends 1 through 3 (see below).

For example, it would be a good idea to as- sign channels for drums to a group. You can control the level of drums using the corre- sponding group fader without altering the balance.

[SOLO] switches

ST

1-2

3-4

ST

1-2

3-4

ST

1-2

3-4

STEREO BUS

Channels which are assigned
to the stereo buss
ST	ST	ST	ASSIGN TO
			STEREO OUT
1-2	1-2	1-2
3-4	3-4	3-4
		GROUP 1-2 BUS

STEREO

Assigned to the stereo buss

[SOLO] switches

<Note>: If any of the [SOLO] switches is set to ON, the solo signal is monitored, while the signal selected by the [MONITOR SELECT] switch is interrupted.

			GROUP 1, 2
ST	ST	ST	ASSIGN TO
			STEREO OUT
1-2	1-2	1-2
3-4	3-4	3-4
		GROUP 3-4 BUS

GROUP 3, 4

Channels which are assigned to the group busses

40