Fostex LR16 manual Project management, Selecting a project, Creating a new project

Model LR16 [Recorder functions / Project management]

Project management

Selecting a project

You can select the desired project by the fol- lowing procedure.

<Note>: If you select a project which does not match the setting of the "Default FS" menu item in the "System" menu of the MENU mode, the "FS/Bit" information flashes on the Home screen for warning (the infor- mation shows the current setting of the "De- fault FS" menu item).

In such a condition, you cannot perform playback or recording. To perform playback or recording, reselect the "Default FS" menu item to the same FS/Bit as the project (see page 83 for details about how to set it).

By selecting "<New project>" shown at the bottom of the list, you can create a new project on the hard disk (see “Creating a new project" below).

(4)Use the [MENU] dial to highlight a desired project and press the [ENTER] key.

The display now shows the Home screen for the selected project.

Creating a new project

You can create a new project on the hard disk by selecting "<New project>" shown at the bottom of the list.

<Note>: You can make recording to the project created by the following procedure only in the insert mode (i.e., the [NEW PROJECT] key is off).

(1)Press the [ENTER] key to bring up the MENU screen.

When you bring up the MENU screen for the first time, "Mark point" is highlighted.

(2)Use the [MENU] dial to highlight "Project" and press the [ENTER] key.

The display now shows the project menu.

(1)Press the [ENTER] key to bring up the MENU screen.

When you bring up the MENU screen for the first time, "Mark point" is highlighted.

(2)Use the [MENU] dial to highlight "Project" and press the [ENTER] key.

The display now shows the project menu.

(3)	While "Select" is highlighted, press the	(3)	While "Select" is highlighted, press the
	[ENTER] key.		[ENTER] key.
	The display now shows the project list.		The display now shows the project list.

65