Fostex LR16 manual Rolling back a project, Name editing example, Right, Use the 3 key to enter a

Model LR16 [Recorder functions / Project management]

[CLEAR] key

[MENU] dial numeric keys

<Name editing example>

The following shows the procedure of com- pletely deleting "PROJ001", the current project name, and entering "Live3" as the new name.

Rolling back a project

Instead of the undo/redo function, you can retrieve the pre-edited condition of an edited project.

<Memo>: Each time you perform recording or editing (including punch-in/out, additional re- cording, etc.), the LR16 stores the previous project data as an ADL file to the LOG folder on the hard disk, as shown below. By selecting a desired ADL file, you can roll back the project to the previous condition, which is similar to the undo function.

(1) Rotate the [MENU] dial counterclockwise

to move the cursor to the leftmost position.

LOG Folder

TAKE01 TAKE02 TAKE03 TAKE04

(2)	Press the [CLEAR] key repeatedly until all
	characters of the current name are deleted.
(3)	Use the "5" key to enter an uppercase "L".
(4)	Use the "4" key to enter a lowercase "i".
(5)	Use the "8" key to enter a lowercase "v".
(6)	Use the "3" key to enter a lowercase "e".
(7)	Use the [MENU] dial to move the cursor to
	the right.
(8)	Use the "3" key to enter a "3".

(5)After editing the name, press the [ENTER] key.

The display now shows the Home screen of the renamed project.

Each ADL file is stored with a different file name as below.

TAKE01: ADL file for a newly created (blank) project.

TAKE02: ADL file for a project which has been recorded for the first time.

TAKE03: ADL file for a project which has been edited for the first time.

TAKE04: ADL file for a project which has been edited for the second time.

The following shows the procedure of replac- ing the current project (TAKE04) with the pre- edited project (TAKE02).

(1)Press the [ENTER] key to bring up the MENU screen.

When you bring up the MENU screen for the first time, "Mark point" is highlighted.

(2)Use the [MENU] dial to highlight "Project" and press the [ENTER] key.

The display now shows the project menu.

67