CSS components

If a memory module is installed and you pull the lever strongly outwards, the memory module pops up. Doing so may cause a device failure.

Please observe the safety information in chapter "Important information" on page 27.

ITo guarantee that all memory modules in the relevant storage mode have identical characteristics, you must always replace 4 memory modules on each memory board. The only exception is memory boards running in spare mode or in independent mode - these only require 2 memory modules to be replaced.For more information on the individual storage modes, see the "System Board D3141 for PRIMERGY RX600 S6 Technical Manual".

Figure 30: Removing a memory module

ÊPress the holders on either side of the memory slot concerned outward (1).

ÊPull the defective memory module out of the slot (2).

112

Operating Manual

RX600 S6

Page 112
Image 112
Fujitsu RX600 S6 manual Removing a memory module