Fujitsu RX600 S6 manual Non-hot-plug components

CSS components

8.2Non-hot-plug components

VCAUTION!

●The actions described in this section may only be performed by personnel with the appropriate technical training. (The device can be seriously damaged if it is opened without authorization or if repairs are attempted by untrained personnel.)

●The circuit boards and soldered parts of internal options are exposed and can be damaged by static electricity. Before handling them, first touch a metal part on the server to discharge static electricity from your body.

●Do not touch the circuitry on boards and soldered parts. Hold the metallic areas or the edge of the circuit boards.

●Touch only the specified part of the printed circuit board. Failure to do so may cause injury. It may also cause failures.

●Please observe the safety information in chapter "Important information" on page 27.

If a defective non-hot-plug component is detected (for more information, see chapter "Starting up and operation" on page 57 and the "ServerView Suite Local Service Concept - LSC" manual on the ServerView Suite DVD 2), proceed as follows:

ÊExit all applications and shut down the server properly (see section "Switching the server on and off" on page 69).

ÊPull all power connectors out of the power outlets.

ÊRemove the server from the rack (see section "Rack installation/removal of server" on page 43) and place the server on a table, for example.

116 Operating Manual RX600 S6