Fujitsu RX600 S6 manual Removing the HDD/SSD module, Installing the 2.5-inch HDD/SSD module

CSS components

Figure 21: Installing the 2.5-inch HDD/SSD module

ÊCarefully push the HDD/SSD module into the empty slot (1) until it stops.

ÊPush the handle completely (2) in the direction of the arrow until the locking mechanism engages.

8.1.3.4Removing the HDD/SSD module

VCAUTION!

●Only remove an HDD/SSD module during operation if the drive is not currently being accessed. Observe the control LEDs for the corresponding HDD/SSD modules (see "Indicators on the hot-plug HDD/SSD modules" on page 62).

●Under no circumstances should you remove an HDD/SSD module while the system is in operation if you are not sure that the hard disk drive or solid state disk is operated by a RAID controller and belongs to a disk array that is operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.

An HDD/SSD module can only be replaced during operation in conjunction with a corresponding RAID configuration.

●All HDD/SSD modules (drives) must be uniquely identified so that they can be reinstalled in their original mounting locations later. If this is not done, existing data can be lost.

RX600 S6 Operating Manual 99