Fujitsu RX600 S6 manual Switching the server on and off, Starting up for the first time

Starting up and operation

5.2Switching the server on and off

VCAUTION!

●If nothing appears on the screen but flickering stripes after switching on the server, switch the server off immediately (see chapter "Troubleshooting and tips" on page 79).

●The On/Off button does not disconnect the server from the mains voltage. To completely disconnect it from the mains voltage, remove the power plug(s) from the socket(s).

●Do not move, strike, or shake the server when it is turned on. This can damage the hard disk in the server and cause data loss.

●Turn the server on when the temperature is in its operating environment range (10 – 35°C). For details on the operating environment, refer to "Safety Precautions". When operating the device outside of this operating environment, the server may operate improperly, damage data etc. Furthermore, Fujitsu cannot be held responsible for any related damage, malfunction, or loss of data, etc.

●Be sure to wait for 10 seconds or more after shutdown before turning the server on.

●After connecting the power cords, press the On/Off button after it passes for more than 10 seconds.

Switching the server on

The power-on indicator (see figure 8 on page 58) lights up orange (standby mode) when the server is connected to the mains.

–Starting up for the first time:

For the Japanese market, please refer to " はじめにお読みください ".

ÊPress the On/Off button (see figure 8 on page 58).

ÊInsert ServerView Suite DVD 1 in the DVD drive.

ÊFollow the on-screen instructions (see also section "Configuring the server and installing the operating system with the ServerView Installation Manager" on page 73 or section "Configuring the server and installing the operating system without the ServerView Installation Manager" on page 74).

RX600 S6 Operating Manual 69