Fujitsu RX600 S6 manual Adding a hot-plug power supply unit, Removing a PSU dummy module

CSS components

ÊSlide the new power supply unit into the empty slot until it clicks into place.

IMake sure that the new power supply unit engages correctly in the mounting location and is locked in position. This is the only way to prevent the power supply unit from sliding out of its mountings and being damaged during transportation.

ÊThread the cable through the cable clamp (see figure 6 on page 54).

ÊPull the cable clamp tight to secure the power cord.

ÊConnect the newly installed power supply unit to the mains.

If everything is functioning correctly, the green LEDs 1 and 3 (see "Indicators on the hot-plug power supply units" on page 67) at the rear of the power supply unit will now light up.

8.1.1.2Adding a hot-plug power supply unit

Figure 15: Removing a PSU dummy module

ÊRemove the PSU dummy module as follows:

1.Press the two metal clips together (see arrows (1) in figure above).

2.Pull the PSU dummy module out of its slot (see arrow (2) in figure above).

ÊSlide the new power supply unit into the empty slot until it clicks into place.

IMake sure that the new power supply unit engages correctly in the mounting location and is locked in position.This is the only way to prevent the power supply unit from sliding out of its mountings and being damaged during transportation.

RX600 S6 Operating Manual 89