Installation, Quick install, Electrical installation | GE P485

GE Consumer & Industrial

P485 Modbus to Profibus

Converter

Chapter 2: Installation

Quick install

PROCEDURE 1. Snap the P485 on to the DIN-rail (see DIN-rail mounting on page 2–5).

2.Connect the Profibus cable (see Profibus connector on page 2–2).

3.Connect the serial Modbus network cable (see Modbus connector on page 2–4for details).

4.Connect a PC using the configuration cable (see Configuration cable on page 2–3).

5.Connect the power cable and apply power to the unit (see Power connector on page 2–4for details).

6.Start the EnerVista P485/D485 Setup software.

7.Normally, the EnerVista P485/D485 Setup detects the correct serial port. If this does not occur, select the correct port through the Port menu item.

8.Configure the P485 using EnerVista P485/D485 Setup and download the configuration to the unit.

9.Configure and power-up the Modbus network device for communication.

Electrical installation

OVERVIEW The location of the various electrical connectors is shown below.

P485 MODBUS TO PROFIBUS CONVERTER – USER GUIDE

2–1

Image 11

GE P485 instruction manual Installation, Quick install, Electrical installation

Contents

GE Multilin P485 Modbus to Profibus ConverterPage P485 Modbus to Profibus Converter Table of contents Software Frame Miscellaneous Getting started Introduction Input and output definition Document conventions About the P485 Modbus to Profibus Converter FeaturesFeatures Communications SpecificationsMechanical Housing Ordering Electrical installation InstallationQuick install Pin Signal Description Profibus connector pin assignments Pin Description Configuration cable pin assignments P485 end Configuration cable PC end Indicators and switches Mechanical installation Number Description State Status P485 status indicators Input/output bytes required Modules Profibus installation procedure Poor performance Troubleshooting Overview Data exchange Memory Map Address Contents Access Blocks Protocol configuration Data Exchange Introduction Installation procedureSoftware overview Select Configuration Wizard and click on OK Using the EnerVista P485/D485 Setup software Typical network arrangement Sub-network data flow Address Command Software Overview P485 Modbus to Profibus Converter User Guide Software Overview Configurator main window Configuration main window Information window Function Description Fieldbus configuration P485/D485 configuration P485/D485 configuration Parameter Description Range Modbus network configuration Software Overview PLC Communication model P485 scan list Basic settings Menu Nodes Communication Model P485 Modbus to Profibus Converter User Guide Communication Model Frame editor Frame and command editors Select command window Command editor Query Column Select ‘Add Command’ as described earlier Main window Modbus network monitor Modbus network and node monitors Start / Stop sub network scanning Node monitor Update OFF Update on Command Area Control and status registers Advanced functions Code Name Description Bits Name Description Handshake bits themselves bits 14 Code Error Description Fieldbus control system Input/output data during startup Mailbox command Advanced fieldbus configuration Advanced Functions Overview Application example Type Parameter Address Format Read/write For the MM2, we have Parameter User map data Address Modbus user map setup MM2 meter user map setting System configuration System configuration DB9 pin Description Setup Software Starting Configuration Wizard Modbus network properties Selecting the SUB-NETWORK Properties Parameters configured for Pqmii 11 Connect devices to sub-network Connect Devices to the SUB- Network 14 Select parameter window Select Parameters for Each Node 17 Configuration report Queries 20 Save device file 21 Expanding the tree 23 Changing configuration parameters for a query 25 Opening a saved configuration file Profibus network setup Release Dates WarrantyMiscellaneous Revision history 10-2 6-3 P485 Modbus to Profibus Converter Index Power Supply