GE ZET2P, ZET2S, ZET1S, ZET1P owner manual Oven racks

Models: ZET1P ZET2P ZET1S ZET2S

1 128
Download 128 pages 4.21 Kb
Page 34
Image 34
Oven racks

Care and Cleaning

Wall Oven

Oven racks

The racks may remain in the oven during the self-cleaning cycle without being damaged.

Periodically, after several self-clean cycles, the oven racks may need to be lubricated using the Graphite Lubrication shipped with your wall oven. To order additional Graphite Lubrication, call our National Parts Center 800.626.2002 and reference WB02T10303.

1Remove rack from the oven. See the Full extension oven racks section.

2Fully extend the rack on a table or countertop. Newspaper may be placed underneath the rack for easy clean up.

6Open and close the rack several times to distribute the lubricant.

7Replace the cap on the lubricant and shake it again. Turn the rack over and repeat steps 3, 4, 5 and 6.

3If there is debris in the slide tracks, wipe it away using a paper towel. NOTE: Any graphite lubricant wiped away must be replaced.

4Shake the graphite lubricant before opening it. Starting with left slide mechanism of the rack, place four (4) small drops of lubricant on the two (2) bottom tracks of the slide close to the bearing carriers.

Left side

Rack up-side-down

Right side

Left side

Rack right-side-up

5Repeat for the right slide mechanism of the rack.

Right side

34

Rack right-side-up

Rack up-side-down

8Close the rack, turn rack right-side-up and place in the oven. See the Full extension oven racks section.

9Repeat above steps for each rack.

NOTE: Do not spray with Pam® or other lubricant sprays.

Page 34
Image 34
GE ZET2P, ZET2S, ZET1S, ZET1P owner manual Oven racks