Hansol Multitech Uromat 3000 installation instructions Operation in the Service Mode, Equipment

3.23 Operation in the Service Mode

a. Connection of a Laptop

To establish a connection with the URO controller, a PC/laptop is required.

Equipment:

⇒PC or laptop with color display (black/white is also sufficient, but makes operation more difficult)

⇒486 processor, 16 MB RAM

⇒Windows 3.x Win 95 operating system (Windows NT can cause difficulties with the Com interface)

⇒Hard drive

⇒Serial connection cable (9-pole, Sub-D connector to a 9-pole, Sub-D socket, connected 1 - 1), length > 1m.

⇒Current version of the "hp-Service" software

b. Procedure

∙Switch off the URO

∙Connect the PC and the URO CPU board using the connection cable

∙Switch on the URO

∙After approx. 1 s, the service LED will begin to blink

∙Switch on the PC

∙Start the PC software

∙Set the PC software to monitor. The terminal screen will appear

∙Set the service switch on the CPU board to the up "Service" position

∙After approx. 1 s, the service LED will switch to continuously on

∙The start message of the service menu will appear on the screen.

U	U	RRRR	OOO	333	000	000	000
U U		R R	O O		3 0 00 0 00 0 00
U	U	RRRR	O O	33	0 0 0 0 0 0 0 0 0
U U		R R	O O		3 00 0 00 0 00 0
	UUU	R R	OOO	333	000	000	000
			Service mode
		(1)	Input test
		(2)	Analog test
		(3)	Handcontrol and footswitch test
		(4)	Axis calibration
		(5)	Versioncheck

Select testmode

06/00 - 59 of 90 - 0116 7201

Rev. 00 © 2000 Hans Pausch Röntgengerätebau Graf -Zeppelin-Str. 1 D-91056 Erlangen ALL RIGHTS RESERVED Ru