1.TECHNICAL DATA
1.1General Safety Information
Maintenance and repair may be performed only by an office that is authorized by the manufacturer.
In the Federal Republic of Germany, electrical installation of medically used rooms must conform to VDE Regulation 0107. In all other countries, the particular applicable national regulations take precedence and must be observed. These can be found in the system project plan.
During installation, it must be assured that all ground wire connections provided by the manufacturer must be connected prior to starting up the unit.
The ground wire between the individual components and the power supply must be connected as shown in the Wiring Diagram.
The regulations provided by the trade unions for occupational safety and prevention of accidents must be observed.
No work may be performed on parts that are under power (above 42 V).
This condition applies for both measurement and adjustment work steps. However, special care is required when performing these worksteps.
If the operating instructions call for voltage to be switched on for unit movements, the system must be shut down immediately following such tests.
The radiation regulations must be observed while making settings and checks that must be performed under
1.2 Component Weights
Unit column | approx. 320 kg | |
Table | approx. 230 kg | |
Tube unit support arm | approx. | 50 kg |
Footswitch | approx. | 5 kg |
Total weight, incl. tube unit, collimator, |
|
|
adjustable Bucky and I.I.: | approx. 730 kg | |
1.3 Component Dimensions
Unit column with table and tube unit support arm on the pallet.
2050 mm x 1015 x 1800 mm
1.4 Packaging Dimensions and Weights
Unit column with table, incl. accessories | 2050 mm x 1015 mm x 1890 mm | |
| approx. 900 kg |
|
Transport carriage | 1800 mm x 200 mm x | 200 mm |
| approx. 85 kg |
|
0116 7201 | 06/00 | |
Rev. 00 © 2000 Hans Pausch Röntgengerätebau Graf
