Harrison Labs V2.0.2 Control Surfaces Mackie, Control Surfaces Generic Midi, AutoConnect, Solo

26.0 Mixbus Options

Control Surfaces: Mackie

If you are using a Mackie Logic protocol control surface then this should be ON.

Control Surfaces: Generic MIDI

If you are using a generic MIDI controller to control Mixbus knobs then this should be ON.

AutoConnect

•Auto-connect Inputs to Physical Inputs: When a new track is created, Mixbus will automatically connect the next available physical input to the track.

•Manually Connect Inputs: When a new track is created, Mixbus will leave the Input un-assigned and the user must assign it manually before trying to record.

Monitoring

See section 21.0, "Monitoring"

Metering: Fall Off Rate

The decay rate of audio meters, ranging from Off (instant decay) to Slowest (6.6dB/sec decay rate)

Metering: Hold Time

The hold time for the peak-hold indicators. Ranges from Off (no display) to Slowest (5 second hold). Note: This is only shown in Mixbus for compatibility with Ardour.

Solo

Soloing a track will mute all non-soloed tracks.

•Latched: (default ON) If this is on, then multiple tracks may be soloed at once. If this is OFF, then Soloing a track will un-solo previously soloed tracks (only one solo allowed at a time).

•Solo In Place: (default ON)

•Solo Via Bus: (default OFF) The Solo signal will appear at the "Control Output", if one is configured (note: only shown in Mixbus for compatibility with Ardour).

•Show Solo Muting: (default OFF) If this is ON then when a solo is engaged, non-soloed tracks will show a mute indication.

•Solo Overrides Mute: (default OFF) This allows the track to be heard when soloed, even if the track's Mute is engaged.

Crossfades

See section 15.0 Editing Tools & Modes for more information about crossfades.

•Crossfades Active: (default ON) This is only provided for compatibility with old sessions. Mixbus no longer uses separate crossfades.

•Crossfades Auto: (default ON) This is only provided for compatibility with old sessions. Mixbus no longer uses separate crossfades.

•Use Region Fades: (default ON) If this is off, then region fades will be ignored and all regions will start and end abruptly.

•Span Entire Overlap: (default OFF) When 2 regions are overlapped the top region will have a fade in/out assigned that covers the entire length of the overlap.

•Short: (default ON) When 2 regions are overlapped the top region will have a very short fade in/out assigned, depending on the Short Crossfade setting defined in Preferences/Misc.

Section 26.0 - Mixbus Options 53 Mixbus User Guide