Hitachi CP-X267 user manual Manual network connection setting -Wireless LAN

2.. Equipment connection and network setting

2..4 Manual network connection setting –Wireless LAN

The projector and PC can communicate in both of Ad-Hoc and Infrastructure modes, using the designated wireless network card on the projector.

This section is intended to explain how to set up wireless LAN connection manually.

2..4..1 Preparation for wireless LAN connection

Fig. 2.4.1.a Without an access point communication (Ad-Hoc)

Fig. 2.4.1.b With an access point communication (Infrastructure)

*Ad-Hoc is one of the wireless LAN communication methods without having access point to communicate.

*Infrastructure is one of the wireless LAN communication methods with having access point to communicate. If certain quantities of equipments are used, this mode is efficient.

If communicating with existing network, contact your network administrator.

First, insert the wireless network card into SD card slot (& Using an SD card of the User’s Manual (concise) ).

Then, make PC ready for wireless communication.

In case IEEE802.11b/g wireless LAN device is built-in the PC, make it valid and make other network connections invalid. If wireless LAN device is not built-in the PC, connect IEEE802.11b/g wireless LAN device and install device driver. (Refer to the user guide for PC and wireless LAN device for detail.)

16