Honeywell IV REV B user manual Enable Health Check on the Fusion DVR

Fusion IV DVR User Guide

Health Check

FVMS Health Check is used to monitor the status of Network, Video, Recording, and HDD storage space on remotely connected Fusion DVRs. Health Check also provides the user with detailed information on each of the DVRs connected, including the software version running, whether cameras are recording in Motion or Continuous mode and other important information. The DVR transmits this information on port 4005 (default). You can also enable E-mail alarms to be sent on a Health Check Event (Warning or Failure event).

Highlights:

•Can monitor multiple DVRs on the Health Check Main page – up to 100 DVRs.

•Able to define the number of occurrences before a Warning or Failure alarm is triggered.

•Check interval times allow FVMS to check the Fusion DVRs status once every 10 minutes or up to once every 7days.

•Independently enable or disable Health Check on each connected Fusion DVR.

•Independently select warning and failure notification counts for Video Loss, Recording failures, Disk Free Space %, and Storage Failures.

•Enable custom Voice Warning on Failure alert.

•Detailed status screen provides the following information:

•DVR Information: including last Health Check time, Total # of channels recording, DVR software version running, current working drive, and disconnected time.

•Video and Recording information: including the recording status of each camera channel and whether or not it is Motion or Continuous, and if there is a Video Signal from each of the channels

•HDD Storage Status Bar: indicates the amount of Free and Used space remaining on the HDD.

•Enable an E-mail to be sent on a Warning or Failure Health Check Event – Enabled through the Admin>Enable Email Alarm setup window.

•Ability to Export Status Summary Information, from each independently selected DVR, to HTML, TXT, or Excel formats.

•Summary information of Network Status, Disk Status, Video Status, Capture Status and Storage Status indicating Good, Warning or Failure, along with the specifics about each. Also includes the overall Total status of the DVR.

Enable Health Check on the Fusion DVR

1.Enter Setup on the DVR.

2.Click the Network tab.

3.Clear the Disable Remote Control check box.

4.Select the Enable Health Check check box.

Note The default connection port is 4005; only change this if necessary.

5.Click Apply.

6.Click OK.

________________________________________________________________________________________________________

Document 800-05305V1 Rev B	131
10/11