If you have a calibration pattern from a recent print, you can use it to calibrate the heads. Press (Cancel) and go to the next step. Otherwise, press .
The printer prints a jet map test pattern for printheads
➋
➌
➊
➋
➌
Fig.
➊Head number
➋Test pattern and codes
➌Jet number
◆If a line segment is missing or broken, the jet listed in the same column is out. In Fig.
◆If a line segment is marked with a code letter, it has already been detected by the software, so no further action by you is required. This data, however, may be requested by MacDermid ColorSpan Technical Services (phone:
Note | If this test |
| than twelve jets are missing on any one printhead, |
| the printhead may be improperly seated. Try reseat- |
| ing the printhead, and print another Jet Coverage |
| pattern. |
|
|
7.When the calibration pattern has printed, the control panel displays a menu with the following options:
◆Report individual bad jets — enables you to report a bad jet.◆Clear individual bad jets — enables you to clear (mark as good) a jet.◆View current bad jets — lists the bad jets on a given printhead.
Manual Calibrations |