HP 0706124 REV B manual AutoTune, Quality Check Mode

AutoTune

Quality Check Mode

AutoTune runs AutoSet automatically at intervals you specify. When you use the AutoTune scheduler to run AutoSet, AutoSet always performs its three calibrations without prompting the user or canceling due to too many bad jets. You can use the Quality Check Mode feature to handle AutoSet errors, with or without user intervention.

To run AutoSet at specified intervals (AutoTune):

1.On the Front Page screen, press the ￿ (Menu) key to enter the menu system.

2.Press the ￿ (Menu In) key display the Calibrate Printer menu.

3.Press the ￿ key to highlight AutoTune.

4.Press the ￿ (Menu In) key.

The control panel prompts you to specify an AutoTune interval.

5.Press ￿ (Proceed).

The control panel displays this message:

Run AutoSet every 0 prints.

6.Press the ￿ key repeatedly to increment the AutoTune inter- val to the number of prints you desire.

7.Press ￿ (Proceed).

8.Press the ￿ (Menu Out) key repeatedly until the Front Page screen is displayed. Press the Online/Offline button to return the printer to the Ready state.

When you run AutoSet manually, the software notifies you if there are any jet or alignment problems so that they can be addressed. When AutoTune runs AutoSet at scheduled intervals, you can use the Quality Check Mode feature to handle AutoSet errors. For instructions on setting the Quality Check Mode, see page 2-13.

4-20 AutoTune