HP 0706124 REV B PD Primer Door, PG Purge, SC System Calibrations, SM System, SS Service Station

Table B-1. Actions and Warnings

W-PC-3 - Head Height Changed -	Change in head height has invali-	Run AutoSet (page 2-7).
Recalibrate	dated calibration.
W-PC-4 - AutoJet - Jets Not Mapped	Not all missing jets could be	Prime/clean printheads (page 5-3),
Out	replaced.	or increase number of passes (page
		3-7).
(PD) Primer Door
A-PD-1 - Door Opened, Prime Not	The primer door is open.	Close the primer door.
Selected
(PG) Purge
W-PG-1 - Pens Require Purge	The printheads should be purged.	Purge all printheads (page 5-11).
(SC) System Calibrations

W-SC-1 - Media Adv. Run Out Not	Calibration was reset or not per-
Calibrated	formed.

Calibrate media advance (page 4-4).

W-SC-2 - White Point Not Calibrated Calibration was reset or not per- formed.

Calibrate white point (page 2-17).

W-SC-3 - Media Thickness Sensor	Calibration was reset or not per-	Calibrate media sensor (page 2-17).
Not Calibrated	formed.
W-SC-4 - Head Height Not Cali-	Calibration was reset or not per-	Calibrate head height (page 2-17).
brated	formed.
W-SC-5 - Printer Length Not Known	Calibration was reset or not per-	Calibrate printer length by restarting
	formed.	printer.
(SM) System
A-SM-1 - Printer Not Imprinted	Defective electronics assembly.	Call service provider for replacement
		electronics.
A-SM-2 - Release S/W Found Debug	Defective software.	Call service provider for updated
S/W		software.
(SS) Service Station

W-SS-1 Service Station Tray Not	The service station is not installed, or
Present	it is installed too far to the right.

Install service station properly, or defeat service station sensor (page 1-13).

(TC) Top Cover

A-TC-1 - Cover Open The top cover is open. Close the top cover.

(TU) Take Up

A-TU-1 - Takeup Full The media takeup spool is full.

Unload the takeup spool and reload media (page 3-24).

Diagnostics B-7