HP 0706124 REV B manual VN VideoNet, WP White Point

Table B-1. Actions and Warnings

A-TU-2 - Takeup Stall The takeup motor has stalled.

Check for mechanical interference or binding, overloaded spool, out of balance spool, or failure in electron- ics or motor.

W-TU-1 - Takeup Nearly Full	The media takeup spool is almost	Unload the takeup spool and reload
	full.	media (page 3-24).
W-TU-2 - Takeup Connected - Slip-	The media takeup core is slipping.	Reload the media (page 3-24).
ping
W-TU-3 - Takeup not Loaded	Takeup Mode ON, but takeup spool	Load takeup (page 3-24) or turn
	is not loaded.	Takeup Mode OFF (page 2-11).
(VN) VideoNet
W-VN-1 - VideoNet not Connected	The printer cannot detect a print	Connect cable, turn on server, add
	server.	printer to server.
(WP) White Point
A-WP-1 - White Point Drift Too Large	Image sensor white point is invalid.	Clean LEDs and white point chip.
W-WP-1 - White Point Drift Detected	Image sensor white point is varying.	Clean LEDs and white point chip.
W-WP-2 - White Point Chip Missing	The image sensor white point chip	Install/clean white point chip, or call
	cannot be seen.	Tech Support.

B-8 Diagnostics