14.The control panel asks whether you want to use the takeup system.
See “Takeup Options” on page
◆If you will be printing without using the takeup system,
or if you will be performing a Media Feed Calibration, press the key to skip loading the takeup. See “Media Feed Calibration” on page
◆To use the takeup system, press the key.
15.Press and hold the key until the end of the media reaches past the takeup spool.
16.Load an empty media core onto the takeup spool, and load the core and spool into the printer’s takeup spool holder.
See steps 3 through 5 for detailed instructions.
17.Grasping the middle of the media web, pull straight back and tape the middle of the web to the takeup core.
Note | Be sure that the direction you wrap the media |
| around the takeup spool is consistent with the direc- |
| tion specified in the Takeup Control option of the |
| menu (see “Takeup Options” on page |
| details). The default direction is Image Outside |
| (printed image facing out). |
|
|
18.Add a small amount of slack (a “supply loop”) to the media, to prevent the takeup from pulling the takeup spool out of the printer.
19.Press the key to continue.
The control panel displays an informational message sug- gesting that you perform a Media Feed calibration.
20.Press the key to perform a Media Feed calibration, or to skip the calibration.
See “Media Feed Calibration” on page
You are now ready to begin printing. The printer will verify that the media is wide enough for each print job it receives.
Loading Media |
