Check the ink cartridges

The product prompts you to align ink cartridges every time you install or replace an ink cartridge. You can also align the ink cartridges at any time from the product’s control panel or by using the HP software installed with the product. Aligning the ink cartridges ensures high-quality output. For more information, see Align the ink cartridges. If the alignment fails, check to make sure the cartridges are installed correctly, and start the ink cartridge alignment. For more information, see Alignment fails.

Make sure that all latches and covers are closed properly.

Check the computer system

Make sure that your computer is running one of the supported operating systems.

Make sure that the computer meets at least the minimum system requirements.

Check the device to ensure the following

Power light is on and not blinking. When the device is first turned on, it takes approximately 45 seconds to warm up.

The device is in the Ready state, and no other lights on the device control panel are lit or blinking. If lights are lit or blinking, see the message on the device control panel.

Ensure power cord and other cables are working, and are firmly connected to the device.

All packing tapes and materials are removed from the device.

Duplexer is locked into place.

Paper is loaded correctly in the tray, and is not jammed in the device.

All latches and covers are closed.

Software installation suggestions

Verify installation preliminaries

Make sure to use the HP software CD that contains the correct installation software for your operating system.

Before installing software, make sure that all other programs are closed.

If the computer does not recognize the path to the CD drive that you type, make sure that you are specifying the correct drive letter.

If the computer cannot recognize the HP software CD in the CD drive, inspect the HP software CD for damage. You can download the device driver from the HP Web site (www.hp.com/support).

Check or perform the following

Make sure the computer meets the system requirements.

Before installing software on a Windows computer, ensure all other programs are closed.

If the computer does not recognize the path to the CD drive that you typed, ensure you are specifying the correct drive letter.

Troubleshoot installation issues

123

Page 127
Image 127
HP 4500 - G510a Software installation suggestions, Check the computer system, Check the device to ensure the following