3.Refer to the upper right hand corner of the screen for Handshaking line status. RTS, CTS, DSR, and DTR should all be HIGH. The DCD line is not looked at by the terminal emulation program therefore its status can be ignored. If these signals are not high at this point, check to ensure the correct cable is connected.
4.Depress function key: F1.
NOTE: The F1 key in TERM sends the character sequence
The main configuration menu will appear as shown in Section 7.2.1. From this point on, configuration of Print Master will be accomplished by following the menus that will prompt you.
Print Master will respond to the receiving of
Bay Technical Associates |
|
Model 706C Print Master |
|
Copyright 1989 |
|
Revision 3.00 |
|
Total Memory : 1024K Bytes |
|
Status | 1 |
Set Serial Port Configuration | 2 |
Set Input Inactivity Timeout | 3 |
Set Number of Printers | 4 |
Program Printer Select Code | 5 |
Set Printer Select Mode | 6 |
Set Form Feed Mode | 7 |
Program Header Page Message | 8 |
Exit | X |
Enter Request:
NOTE: Menu selection is case sensitive. It is recommended that your keyboard be in the CAPS LOCK position.
50
