HP 706C, 710F, 710E, 708D, 708E, 706D, 708C, 706A manual

￿￿￿￿￿￿￿￿￿￿￿!￿￿￿￿￿!￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

All configuration changes must be made through the master configuration port. This master configuration port has access to all options of configuration mode. Please use the following procedure to configure your Print Master 700D, 700E, or 700F model:

1.Connect a dumb terminal (or a PC running a terminal emulation program) to the master configuration port which is Port 6 on the 706D and 706E; Port 8 on the 708D, 708E and 708F; Port 10 on the 710E and 710F. From the factory, all serial ports are preset at 9600 baud rate, 8 word size, 1 stop bit, no parity and XON/XOFF disabled.

NOTE: If you wish to use the BayTech TERM.EXE program to configure your unit, refer to the instructions on the following page.

2.Make sure the keyboard of your computer is in the CAPS LOCK position.

All ports on Print Master must be off-line (i.e., all LEDs must be off except the green power LED).

Send from the keyboard of the terminal or the PC Control-Tfollowed by capital C. These characters will not appear at on the CRT screen, but Print Master will respond with the main configuration menu.

If any red LEDs on Print Master illuminate when Control-Tand C are sent or if Print Master gives no response (no menus appear), this indicates that an incorrect character sequence has been received. If this occurs, wait for Print Master to timeout (LEDs will go out) and resend Control-Tand capital C.

60