Step
Instructions
To print from a serial port of your PC, you must first redirect the parallel output to the serial port via the DOS command C:>MODE LPTx:=COMy:, where x and y are the port designation (e.g., LPT1:=COM1:). You must also configure your PC's serial port to communicate at parameters that match Print Master. This is done via the DOS command C:>MODE COMy: 9600,n,8,1,p, where y is the com port number of your PC. This MODE command assumes you are using factory default values. You may use the SMODE program to operate at serial speeds greater than 9600 bps.
8AUTOEXEC.BAT FILE
To use BayTech's RAMEXEC or RAMTSR software utilities to select between multiple peripherals, you must add commands to your PC's AUTOEXEC.BAT file. If you have to use any of the MODE commands mentioned in Step 7, you should add these commands to your AUTOEXEC.BAT file. See Section 4.5 (PC
9If you have any questions, please call BayTech technical support at
9
