Memory

Memory modules are located on the right side of the computer (viewed from behind). The computer has two memory slots.

Figure 7-28Memory module location

For proper system operation, the SODIMMs must be:

industry-standard 204-pin

unbuffered non-ECC PC3-10600 DDR3-1600 MHz-compliant

1.5 volt DDR3-SDRAM SODIMMs

The DDR3-SDRAM SODIMMs must also:

support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)

contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification In addition, the computer supports:

1-Gbit, 2-Gbit, and 4-Gbit non-ECC memory technologies

single-sided and double-sided SODIMMS

SODIMMs constructed with x8 and x16 SDRAMs; SODIMMs constructed with x4 SDRAMs are not supported

NOTE: The system will not operate properly if you install unsupported SODIMM memory.

The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending on how the SODIMMs are installed. Refer to the following table to identify the SODIMM channel locations.

50 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis

Page 58
Image 58
HP 8300E B8U11UT#ABA manual Memory