
Disk transaction problem.
Cause | Solution | |
|
| |
Either the directory structure is bad or there is a problem with | ||
a file. | Select Properties then select the Tools tab. Under Error- | |
| checking click Check Now. | |
|
|
|
Drive not found (identified). |
|
|
|
| |
Cause | Solution | |
|
| |
Cable could be loose. | Check cable connections. | |
|
| |
The system may not have automatically recognized a newly | See reconfiguration directions in the Solving hardware | |
installed device. | installation problems on page 125 section. If the system still | |
| does not recognize the new device, check to see if the | |
| device is listed within Computer Setup. If it is listed, the | |
| probable cause is a driver problem. If it is not listed, the | |
| probable cause is a hardware problem. | |
| If this is a newly installed drive, run the Computer Setup | |
| utility and try adding a POST delay under Advanced > | |
|
| |
|
| |
The device is attached to a SATA port that has been hidden | Run the Computer Setup utility and ensure Device Available | |
in Computer Setup. | is selected for the device's SATA port in Security > Device | |
| Security. | |
|
| |
Drive responds slowly immediately after | Run Computer Setup and increase the POST Delay in | |
| Advanced > | |
|
|
|
Nonsystem disk/NTLDR missing message. |
|
|
|
| |
Cause | Solution | |
|
| |
The system is trying to start from a diskette that is not | Remove the diskette from the diskette drive. | |
bootable. |
|
|
|
| |
The system is trying to start from the hard drive but the hard | 1. Insert a bootable diskette into the diskette drive and | |
drive may have been damaged. |
| restart the computer. |
| 2. | Check the hard drive format using fdisk: If NTFS |
|
| formatting, use a third party reader to evaluate the |
|
| drive. If FAT32 formatting, the hard drive cannot be |
|
| accessed. |
|
| |
System files missing or not properly installed. | 1. Insert a bootable diskette into the diskette drive and | |
|
| restart the computer. |
| 2. | Check the hard drive format using Fdisk: If NFTFS |
|
| formatting, use a third party reader to evaluate the |
|
| drive. If FAT32 formatting, the hard drive cannot be |
|
| accessed. |
| 3. | Install system files for the appropriate operating system. |
|
| |
Hard drive boot has been disabled in Computer Setup. | Run the Computer Setup utility and enable the hard drive | |
| entry in the Storage > Boot Order list. | |
|
|
|