Processor
1.Prepare the computer for disassembly (see Preparing to disassemble the computer on page 32).
2.Remove the access panel (see Access panel on page 36).
3.Remove the graphics heat sink (see Graphics heat sink on page 65).
4.Remove the processor heat sink (see Processor heat sink – model 6300 on page 66).
5.Rotate the locking lever to its full open position (1).
6.Raise and rotate the microprocessor retainer to its fully open position (2).
7.Carefully lift the processor from the socket (3).
CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and handling them could cause irreparable damage. Once pins are damaged it may be necessary to replace the system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to the processor’s solder connections.
Figure
To install a new processor:
1.Place the processor in its socket and close the retainer. Make sure the slot in the processor fits into the post on the socket.
2.Secure the locking lever. If reusing the existing heat sink, go to step 3. If using a new heat sink, go to step 6.
Processor 69