My HP Brio Doesn’t Start Properly
My HP Brio Doesn’t Start Properly
The HP Brio Doesn’t Power On
Have you checked that...
The HP Brio’s power cord is correctly | Ö |
connected | |
You did not hear a series of beeps when you | Ö |
turned the PC on | |
The HP Brio’s power outlet is working | Ö |
The HP Brio’s voltage switch is correctly set | Ö |
|
| The HP Brio’s | Ö |
|
| press the On/Off switch | |
|
| ||
Advanced Troubleshooting |
| ||
|
| Have you checked that... |
|
|
| The problem is not being caused by an | Ö |
|
| ||
|
| internal device | |
|
| ||
The power supply is working properly | Ö |
If the problem persists, contact your authorized support provider
How
Connect the power cord to a grounded power outlet and to the PC
If you hear a series of beeps when you turn the PC on, refer to page 35
Plug another device into the power outlet and check that it works
1Disconnect the power cord.
2Select the correct setting on the voltage switch located beside the power connector in the rear of the PC.
3Reconnect the power cord.
4Start the PC.
If the LED does not light, check that the status panel connector is connected correctly to the system board. (see page 57).
How
1Disconnect the PC’s power cord.
2Remove the PC’s main cover and lift out the power supply (see page 51).
3Remove internal connectors from any accessory devices you have added and disconnect any add- on expansion cards.
4Reconnect the devices one by one, booting the PC each time to see if it works correctly.
5If you are still unable to localize the fault, contact your authorized support provider.
1When you power on the PC, check that the light on the On/Off button comes on and that you hear the power supply fan.
2If nothing happens, contact your authorized support provider. The original power supply unit may have to be replaced.
19
