HP Enterprise File Services WAN Accelerator manual Policy-Based Routing Deployments, on page

CHAPTER 6 Policy-Based Routing

Deployments

In This Chapter	This chapter describes how to configure the Policy-Based Routing (PBR) to redirect
	traffic to an HP EFS WAN Accelerator or group of HP EFS WAN Accelerators. It
	contains the following sections:
	‹ “Introduction to PBR,” next
	‹ “Overview of CDP” on page 46
	‹ “How PBR works on a Cisco 6500 Platform, Version 12.2(17d) SXB1” on
	page 47
	‹ “Connecting the HP EFS WAN Accelerator to Your Network in PBR
	Deployments” on page 48
	‹ “Asymmetric HP EFS WAN Accelerator Deployments With PBR” on page 49
	‹ “Client-Side HP EFS WAN Accelerator Attached to a Router through a Switch”
	on page 54
	‹ “Client-Side HP EFS WAN Accelerator Attached to an Inside Router” on page 55
	‹ “PBR Between VLANs” on page 55
	‹ “Symmetric HP EFS WAN Accelerator Deployments With PBR and
	Autodiscovery” on page 57
	‹ “Symmetric Deployments with PBR, Autodiscovery, and CDP” on page 60
	This chapter assumes you are familiar with the HP EFS WAN Accelerator
	Management Console (Management Console). For detailed information about the
	Management Console and how to use it, see the HP Enterprise File Services WAN
	Accelerator Management Console User Guide.
	This chapter also assumes that you are familiar with the installation and configuration
	process for the HP EFS WAN Accelerator. For detailed information, see the HP
	StorageWorks Enterprise File Services WAN Accelerator Installation and
	Configuration Guide.
	This chapter provides the basic steps for PBR network deployments. It does not
	provide detailed procedures. Use this chapter as a general guide to these deployments.
	If you need additional assistance, contact HP technical support located at http://
	www.hp.com.

6 - POLICY-BASED ROUTING DEPLOYMENTS

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.5 DEPLOYMENT GUIDE 45