HP Enterprise File Services WAN Accelerator manual Basic Serial Cluster Deployment

A Basic Serial

Cluster

Deployment

To configure HP EFS WAN Accelerator1

The following example illustrates how to configure a cluster of three in-path HP EFS WAN Accelerators in a data center.

Figure 10-2.Serial Cluster in a Data Center

This example has the following parameters:

‹HP EFS WAN Accelerator1 IP address is 10.0.1.1 on a /16

‹HP EFS WAN Accelerator2 IP address is 10.0.1.2 on a /16

‹HP EFS WAN Accelerator3 IP address is 10.0.1.3 on a /16

Each HP EFS WAN Accelerator is configured with in-path peering rules that prevent peering with another HP EFS WAN Accelerator in the cluster and with in-path rules that do not optimize connections originating from these HP EFS WAN Accelerators.

1.On HP EFS WAN Accelerator1, connect to the CLI. For detailed information, see the HP StorageWorks Enterprise File Services WAN Accelerator Command-Line Interface Reference Manual.

2.At the system prompt, enter the following set of commands:

SH1 > enable
SH1 # configure terminal
SH1 (config)	# in-path peering rule pass		peer 10.0.1.2 rulenum 1
SH1 (config)	# in-path peering rule pass		peer 10.0.1.3 rulenum 1
SH1 (config)	# in-path rule	pass-through	srcaddr 10.0.1.2/32 rulenum 1
SH1 (config)	# in-path rule	pass-through	srcaddr 10.0.1.3/32 rulenum 1
SH1 (config)	# wr mem
SH1 (config)	# show in-path	peering rules
Rule Type	Source Network	Dest Network		Port Peer Addr

----------- ------------------ ------------------ ----- --------------

-

1	pass	*	*	*	10.0.1.3
2	pass	*	*	*	10.0.1.2
def auto		*	*	*	*

SH1 (config) # show in-path rules
Rule	Type Source Addr	Dest Addr	Port Target Addr
Port

--------- ------------------ ------------------ ----- ---------------

1	pass 10.0.1.3/32	*	*	--	--
2	pass 10.0.1.2/32	*	*	--	--
def auto *		*	*	--	--

10 - SERIAL CLUSTER AND CASCADE DEPLOYMENTS

HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.5 DEPLOYMENT GUIDE 109