HP Enterprise File Services WAN Accelerator manual EFS WAN Accelerators, Set of commands

Symmetric HP EFS WAN Accelerator

Deployments With PBR and Autodiscovery

In the case where clients and servers are on both sides of the WAN, PBR can be configured on both sides of the network where each router has the reversed rules of the other router.

Figure 6-7.Symmetric HP EFS WAN Accelerator Deployments with PBR

For this example, assume that clients, servers, and HP EFS WAN Accelerators are all on a separate VLANs and the Layer-2 switch is attached to the router fastEthernet0/

0 interface. This example uses the following IP addresses:

	‹	Left-side. Clients=10.0.1.0/24, Servers=10.0.2.0/24, HP EFS WAN
		Accelerator=10.0.3.0/24
	‹	Right-side. Clients=10.1.1.0/24, Servers=10.1.2.0/24, HP EFS WAN
		Accelerator=10.1.3.0/24
	Each router is connected to the WAN through their Fast Ethernet 0/1 interfaces. They
	use the following IP addresses:
	‹	Left WAN = 10.0.4.0/24
	‹	Right WAN = 10.1.4.0/24
To configure the HP	1.	On the left HP EFS WAN Accelerator, at the system prompt, enter the following
EFS WAN Accelerators		set of commands:
	Left-SH > enable
	Left-SH # configure terminal
	Left-SH (config) # in-path enable
	Left-SH (config) # in-path oop enable
	Left-SH (config) # interface in-path ip address 10.0.3.2 /24
	Left-SH (config) # ip in-path-gateway inpath0_0 10.0.3.1
	Left-SH (config) # write memory
	Left-SH (config) # restart
	2.	On the right HP EFS WAN Accelerator, at the system prompt, enter the following
		set of commands:
HP STORAGEWORKS ENTERPRISE FILE SERVICES WAN ACCELERATOR 2.1.5 DEPLOYMENT GUIDE			57

6 - POLICY-BASED ROUTING DEPLOYMENTS