Fax from the document feeder

1.Insert the originals into the document feeder face-up.

NOTE: The document feeder capacity is up to 35 sheets of 75 g/m2 or 20 lb media.

CAUTION: To prevent damage to the product, do not use an original that contains correction tape, correction fluid, paper clips, or staples. Also, do not load photographs, small originals, or fragile originals into the document feeder.

2.Adjust the guides until they are snug against the paper.

3.Press the Setup button.

4.Select the Phone Book menu, and then press the OK button.

5.From the list, select the phone book entry. If no entry exists, use the keypad on the control panel to dial the number.

6.On the control panel, press the Send Fax button. The product starts the fax job.

Manual dial faxing

Usually, the product dials after you press the Send Fax button. At times, however, you might want the product to dial each number as you press it. For example, if you are charging your fax call to a calling card, you might need to dial the fax number, wait for the acceptance tone of your telephone company, and then dial the calling card number. When dialing internationally, you might need to dial part of the number and then listen for dial tones before continuing to dial.

118 Chapter 10 Fax (M1210 Series only)

ENWW

Page 132
Image 132
HP FESSIONAL M1130, FESSIONAL M1210, FESSIONAL CE841A, M1212NF CE841A#BGJ Fax from the document feeder, Manual dial faxing