HP FESSIONAL M1210 manual Problems sending faxes, Change the fax speed, Faxes stop during sending

Change the fax speed

The fax-speed setting is the modem protocol that the product uses to send faxes. It is the worldwide standard for full-duplex modems that send and receive data across telephone lines at up to 33,600 bits per second (bps). The factory-set default for the fax-speed setting is Fast(V.34).

You should change the setting only if you are having trouble sending a fax to or receiving a fax from a particular device. Decreasing the fax speed might be useful when you are trying to send a fax overseas, or receive one from overseas, or if you are using a satellite telephone connection.

1.On the control panel, press the Setup button.

2.Use the arrow buttons to select the Fax setup menu, and then press the OK button.

3.Use the arrow buttons to select the All faxes menu, and then press the OK button.

4.Use the arrow buttons to select the Fax Speed menu, and then press the OK button.

5.Use the arrow buttons to select a speed setting, and then press the OK button.

Problems sending faxes

The document stops feeding in the middle of faxing.

Cause Solution

The maximum length of a page that you can load is 355 mm (14 inches). Faxing of a longer page stops at this measurement.

Print the document on shorter media.

If no jam exists and less than one minute has elapsed, wait a moment before pressing the Cancel button. If a jam exists,

remove the jam. Then, resend the job.

If the item is too small, it can jam inside the document feeder.

The minimum page size for the document feeder is 148 x 105 mm (5.83 x 4.13 inches).

If a jam exists, remove the jam. Then, resend the job.

Faxes stop during sending.

Cause	Solution
The receiving fax machine might be malfunctioning.	Try sending to another fax machine.
The telephone line might not be working.	Do one of the following:
	● Turn up the volume on the product, and then press the
	Send Fax	button on the control panel. If you hear a
	dial tone, the telephone line is working.
	● Disconnect the product from the jack in the wall, and then
	connect a telephone to the jack. Try to make a telephone
	call to verify that the telephone line is working.
A communication error might be interrupting the fax job.	Change the redial-on-communication-error setting to On.

ENWW Solve fax problems 135