HP Legato Networker manual Task 2 On NodeB, Install and Configure the Software

Chapter 6: Microsoft Cluster Disaster Recovery (Windows NT 4.0)

5.Install the MSCS software.

6.Install any required service pack software. Make sure that the version is greater than Service Pack 3.

7.If Node_A is a NetWorker server, configure the tape devices.

8.Log on to Node_A using the cluster account on the domain.

Task 2: On Node_B, Install and Configure the Software

To install and configure the software, on Node_B:

1.Make sure the node has been properly:

•Shut down

•Connected through the shared disks

•Terminated

2.Install Windows NT 4.0 Server Enterprise Edition.

a.Add the server to the domain using the same cluster login account.

b.Create the partitions so the new disk configuration matches the original configuration.

c.Use the same server name (fully qualified DNS if used) and IP address that were used originally.

d.Configure the network adapters and the IP address using the original settings whenever possible.

e.Log on to the domain.

3.Using the Windows NT Disk Administrator, configure the drives to match their previous configuration.

4.Install Windows NT 4.0 Server Enterprise Edition server-specific service packs (Service Pack 3).

6

Task 3: Install and Configure NetWorker

Install and configure the NetWorker software and any required patches on

Node_A and Node_B. For details, refer to the Legato NetWorker Installation

Guide, Microsoft Windows Version.

Legato NetWorker, Release 7.0	121
Disaster Recovery Guide