HP Legato Networker manual NetWorker Client or Storage Node Recovery Summary Procedure

4

NetWorker Client or Storage Node Recovery Summary Procedure

11.Recover the client’s data and SYSTEM save sets using the NetWorker User program.

12.Reboot the computer after the recovery is complete.

13.If you are using an autochanger with Removable Storage enabled:

a.Use the Removable Storage MMC snap-in to mount the tape that contains the bootstrap.

b.Run mmrecov to recover the NetWorker media database and resource configuration files.

c.Stop the NetWorker services.

d.Rename <NetWorker_install_path>\res.R to <NetWorker_install_path>\res.

e.Start the NetWorker services.

f.On the Autochanger Operations dialog box, click Reset to reset the jukebox.

14.Verify the recovery.

NetWorker Client or Storage Node Recovery Summary Procedure

Note: In most cases, the NetWorker server should be fully functional before you begin recovery of its associated clients or storage nodes. However, if the storage device required for a NetWorker server recovery is connected to a remote storage node, you might have to partially recover the storage node before you can recover the NetWorker server. For more information, see “Partial Recovery of a NetWorker Storage Node” on page 82.

To perform a disaster recovery on a NetWorker client or storage node:

1.Replace the hard drive, if necessary. For instructions, see “Replacing a Hard Drive” on page 52.

2.To begin the software recovery, do one of the following, depending the Windows version:

•For Windows .NET and Windows XP Professional NetWorker clients only, perform an ASR recovery if possible. This requires a current ASR disk or ASR backup from which you can create an ASR disk. For instructions, see “Performing Windows ASR Recovery” on page 53. If you use the ASR recovery method, you do not need to perform any of the remaining steps in this summary procedure.

50	Legato NetWorker, Release 7.0
	Disaster Recovery Guide