HP Legato Networker manual 133

Chapter 7: Microsoft Cluster Disaster Recovery (Windows 2000 and .NET)

6.For Windows 2000 systems, install the Cluster Service on Node_A:

a.While Node_B is still detached from the shared SCSI bus, using the Control Panel Add/Remove Programs tool, add the Windows component Cluster Service. The Cluster Setup Wizard appears.

b.Using the Cluster Setup Wizard, enter the same configuration information that was in use prior to the failure of the cluster nodes (including user account, IP addresses, and cluster name).

c.Reboot Node_A.

Note: This step is not required for Windows .NET systems because the Cluster

Service is installed automatically with Windows.

7.For Windows 2000 systems, install the Cluster Service on Node_B:

a.On Node_B, using the Control Panel Add/Remove Programs tool, add the Windows component Cluster Service. The Cluster Setup Wizard appears.

b.Using the Cluster Setup Wizard, select Join An Existing Cluster and enter the cluster name.

c.Reboot Node_B.

Note: This step is not required for Windows .NET systems because the Cluster

Service is installed automatically with Windows.

8.On Node_B, run the net stop clussvc command from a command prompt.

9.Install the NetWorker client software on Node_A.

10.From NetWorker User on Node_A, select the SYSTEM FILES and SYSTEM STATE save sets to recover to the desired point in time prior to the cluster failure. Click Start to begin the recovery process.

11.After the recovery of Node_A is complete, reboot Node_A.

12.On Node_A, run the Cluster Administrator to confirm that the states of the cluster resources were restored to the desired point in time.

13.Start the cluster service on Node_B using one of the following methods:

•Run net start clussvc from a command prompt.

•Using the Computer Management Services tool, right click Cluster Server and select Start.

14.	From the Cluster Administrator on Node_B, verify that the cluster group	7
	can be moved between the nodes by right-clicking the group and selecting
	Move group.
15.	Reinstall the NetWorker client software on Node_B.

Legato NetWorker, Release 7.0	133
Disaster Recovery Guide