HP Legato Networker manual 144

Restoring an Entire Cluster

	•	“Task 4: Install the NetWorker Software” on page 145
	•	“Task 5: Configure NetWorker Device and Autochanger Resources” on
		page 146
	•	“Task 6: Locate the Server’s Bootstrap Save Set ID” on page 146
	•	“Task 7: Recover the Server’s Bootstrap” on page 147
	•	“Task 8: Locate the Server’s Client File Index Save Set IDs” on page 148
9	•	“Task 9: Recover the Server’s Client File Index” on page 149
	•	“Task 10: Re-create the Cluster” on page 150
	•	“Task 11: Recover the Cluster Data” on page 150
	Task 1: Replace the Damaged Hardware
	Replace the damaged equipment with the same or similar model equipment as
	installed previously. Connect all the equipment as previously connected.
	Task 2: Verify Hardware Mappings
	Open the SRM console and set the logical mappings for each node’s managed
	disks and volumes to their original settings. To help complete this step, use the
	information that was recorded from the SRM console prior to the disaster.
	Task 3: Install and Configure the Cluster Software
	Perform a stand-alone installation of Tru64 on the primary node’s stand-alone
	boot drive. This task requires the cluster information that was recorded prior
	to the disaster.
	To install and configure the software:
	1.	Install the base operating system and TruCluster package on the primary
		node’s stand-alone boot drive. For more information, refer to the
		TruCluster installation documentation.
	2.	Configure the network resources.
	3.	Verify that the system topology matches what you recorded, and the
		device layer is configured the same, as follows:
		# hwmgr -view hierarchy
		# hwmgr -view devices
	4.	If the logical disks are enumerated differently than in the original
		configuration, manually reapply the original enumeration to the disks.
	144	Legato NetWorker, Release 7.0
		Disaster Recovery Guide