Removal
DIN
Side
Rail
View
1.Place a screwdriver in the DIN rail latch at the bottom of the unit.
2.Holding the unit, pry downward on the latch until the unit is released from the DIN rail.
ATTENTION
!
Be careful of metal chips when drilling mounting holes for your equipment within the enclosure or panel. Drilled fragments that fall into the equipment could cause damage. Do not drill holes above mounted equipment if the protective debris strip has been removed.
Mounting Template
1.Remove the mounting template from the back of this document.
2.Secure the template to the mounting surface.
3.Drill holes through the template.
4.Remove the mounting template.
5.Mount the unit.
Publication